Alchimy7 Flocon PM is a prewash and washing product designed for the maintenance of matte surfaces.
It is designed to perform both the prewash and the wash.
Very foamy and offering optimal lubrication, it will allow very good glide in order to limit friction on the matte surface as much as possible.
On vehicles without any protection or without any hydrophobic treatment, it is therefore recommended to overdose by about 15% the FLOCON PM and then apply a protection with MATE FINISH PM. Afterwards, the vehicle will be easier to maintain/clean.
Specific References
Dilution
In a foam cannon (connected to a pressure washer) = 40ml to 100ml in a 1L tank.
In a battery-powered foam cannon (electric foamer) or manual (manual foamer) = 25ml to 50ml in a 2L tank.
In a wash bucket = 40ml to 100ml in an 8L bucket of water.
Use
Work out of direct sunlight and on cold surfaces. On a hot bodywork, rinse beforehand to cool it down.
Store Alchimy7 Flocon PM away from sunlight and at a temperature between 10°C and 30°C.
Important
Always apply in the shade, on a cold surface and do not let the product dry.
Use gloves and safety glasses if necessary.
Labeling/Allergens
UFI : T7K8-30EJ-H00C-FRYY
H315: Causes skin irritation.
H318: Causes serious eye damage.
EUH208: Methylchloroisothiazolinone May cause an allergic reaction.
SAS, Sulfonic acids, C14-16 Alkane hydroxides (even numbered) and C14-16 Alkanes (even numbered), Sodium salts, Sodium Laureth Sulfate.
Dangerous, follow the precautions for use

if order before 2pm with Chronopost
+33661657881 or contact@addictauto.com
via our bank/3DSECURE
get € discount
but above all satisfied