Alchimy7 Innova 7 - High protection finishing shampoo - 470 ml

Dilution
Between 40 ml and 100 ml for 10 liters of water depending on the desired result and the level of dirtiness.

Use
Use the 2-bucket technique.

1. Rinse the entire car with clean water.
2. Apply the soapy solution using a wash mitt. Clean by section (1/2 hood, 1/2 door, 1/2 fender, etc.) with straight movements.
3. Rinse with clean water.
4. Dry the vehicle with a drying microfiber.

Tip to enhance gloss and protection:

After rinsing, use the remaining INNOVA7 from your wash bucket (shampoo) to quickly reapply INNOVA7 on the freshly cleaned vehicle. Apply quickly and simply as if you were going to wash the vehicle again (about 2 minutes to go around the vehicle). Then rinse and dry. The level of protection will then be even greater. The water-repellent effect will be even better and the shine will also be enhanced.

NOTE: Do not let dry. Using hot water increases the performance of INNOVA7.
The optimal result will be obtained 24 hours after drying.
Can be used with a foam lance (DO NOT ADD FOAMING ADDITIVE type SNOW FOAM).