Alchimy7 Flocon PPF & CO is the version of Flocon dedicated to the maintenance of protective films such as PPPF, covering, wrapping, and adhesives in general.
It is designed to perform both pre-wash and wash.
Very foaming and providing optimal lubrication, Flocon PPF & CO will not alter the different technical properties of the films applied to vehicles (hydrophobic protection, self-healing effect, etc.).
For vehicles with PPF or Covering, without any protection or hydrophobic treatment, it is advisable to carry out the pre-wash with FLOCON PPF & CO and then opt for SHAMPOO PPF & CO during the wash, which will then offer greater cleaning power.
Can also be used on vehicles with partial covering or partial PPF.
Data sheet
Specific References
Dilution
In a foam gun (connected to a high-pressure washer) = 40ml to 100ml in a 1L tank.
In a battery-powered foam gun (electric foamer) or manual (manual foamer) = 25ml to 50ml in a 2L tank.
In a wash bucket = 40ml to 100ml in an 8L bucket of water.
Use
Work out of direct sunlight and on cool surfaces. On a hot bodywork, rinse beforehand to cool it down.
Store the Alchimy7 Flocon PPF & CO out of sunlight and at a temperature between 10°C and 30°C.
Good to know: Cars, motorcycles, scooters, Trucks, Buses, Motorhomes, Caravans
Important
Do not apply in sunlight or on a hot surface.
Use gloves and goggles if necessary.
Labeling/Allergens
No. UFI: W2CC-70NH-T008-X4QG
H315: Causes skin irritation.
H318: Causes serious eye damage.
H412: Harmful to aquatic organisms, causes long-term adverse effects.
EUH208: Methylchloroisothiazolinone. May cause an allergic reaction.
Dangerous, observe the precautions for use.

if order before 2pm with Chronopost
+33661657881 or contact@addictauto.com
via our bank/3DSECURE
get € discount
but above all satisfied