M-1 GEL COAT COATING 50ML (CERAMIC 9H BOAT)

By Autotriz

9H ceramic treatment for Gel Coat
Boat, yacht, jet ski
Long duration: 3 years

Description

--- Product reserved for professionals who have made the request by email to benefit from a PRO account ---

AUTOTRIZ M-1 Gel Coat Coating is a high-quality professional ceramic treatment made in Germany. This ceramic is specially formulated for epoxy or polyester gel coats.

The M-1 is a unique protection that durably protects the gel coat of boats, yachts or jet skis by forming a very glossy protective layer with highly advanced hydrophobic properties.

The Autotriz M-1 is also an excellent shield against:

UV rays
acid rain
oil
corrosion
salt water
chemical products

Finally, the maintenance of treated surfaces will be extremely simplified thanks to the ceramic which helps to minimize dirt adhesion as much as possible.

PROPERTIES

Extreme hydrophobicity
Hardness: >9H
Excellent protection against rain and sun damage
Ease of cleaning
Perfect adhesion to gel coat surfaces
Weather resistance
Resistance to UV rays and salt water
Prevents dulling and oxidation
More effective product than Siloxane-based protections

For usage and application advice: click on the "USAGE ADVICE" tab above.

Reference AT012M1

Product usage

Dilution
None

Use

Shake the vial well before use.

Prepare 2 or 3 new short-pile lint-free, seamless, edgeless ultrasonic-cut drying (buffing) microfibers such as MADNESS Slogger or KLIN Zero Finish HD for example.
Place one of the supplied suedes (10x10cm) on the applicator block on the "soft foam" side and apply 7–8 drops onto the suede.
Work on small areas of about 50x50cm with moderate pressure. Make sure the surface is perfectly treated by applying crosswise (left to right then top to bottom).
Once the area is covered, wait about 5 to 10 minutes (this time may vary depending on the temperature and humidity level of your workspace) then wipe with the first drying microfiber which will "level" the ceramic layer.
Immediately wipe with the second microfiber until there is no product residue left.
Do not hesitate to use a third microfiber to ensure that no ceramic remains on the surface and check with suitable lamps such as SCANGRIP.
When the layer of M-1 Gel Coat has been applied over the entire boat, you must wait at least 1 hour before applying a second layer.
Wait at least 24 hours before putting the boat back in the water.