NANO COAT V2 35ml (super water-repellent nano coating)

By Fireball

Multi-surface ceramic protection
Super hydrophobic + extreme shine
Durability: up to 12 months

€20.83

Out-of-Stock

Product victim of its success

Enter your email to be notified as soon as it is available.

We recommend you the purchase of the following complementary products

Description

Ceramic protection for car bodywork, wheels, and unpainted raw exterior plastics accessible to everyone

FIREBALL Nano Coat V2 is a ceramic-based protection accessible to everyone, highly loaded with Sio2 (more than 25%).

Its specific composition allows it to bond chemically with your varnish to form a hard and shiny protective layer. Once properly in place, the treatment will protect your bodywork for a long time.

On which surfaces can this ceramic protection be applied?

auto / motorcycle bodywork with varnished paint
raw unpainted exterior plastics
polycarbonate headlights
wheels with varnished paint

What are the advantages of the Nano Coat V2?

Durability: up to 1 year
Average consumption: about 30ml for a large sedan or SUV (including bodywork, wheels, and plastics)
Number of layers: 1
Resistance to products: corrosive and acidic (pH between 3 and 12)
Boosts shine and depth
Anti-yellowing
Strong water-repellent effect
Dries at room temperature (no need for infrared lamp)
Greatly reduces dirt adhesion and makes future washes much easier

The Nano Coat V2 from FIREBALL comes in a storage box including:

1 vial of Nano Coat V2 (35ml)
1 applicator block
3 suede cloths 10x10cm

Good to know

This product can be applied only on an unprotected vehicle.
Product must be used within 48 hours after opening.

Reference FB026NCV2

Specific References

ean13: 8809569643527

Product usage

Dilution
None.

Use

Always work on a clean, dry bodywork ideally previously polished.
Degrease the surface beforehand with an cleaner IPA
Place the suede on the applicator
Shake the bottle
Apply a generous amount of product on the suede then apply in a straight line on an entire part (except very large part that can be "cut" in two)
Do not go back over the areas where you have already applied product
Wait 2 minutes (time varies depending on temperature and humidity).
Make sure there is always a sufficient amount of product applied on the surface
Once you see micro-bubbles appear, wipe (with slight pressure) with a first anti-scratch microfiber dedicated to wiping ceramic coatings
Use a second anti-scratch microfiber dedicated to wiping ceramic coatings to ensure that no trace of product remains
If you wish to apply a second layer, wait 30 min
Wait 24h before using the vehicle or exposing it to water or humidity

Important
Do not apply in the sun or on a hot surface. Use gloves and if necessary goggles.
Work in a covered and closed area. Ideal conditions (15 to 25 degrees and 50 to 70% humidity).
Do not wash the vehicle within 7 days following the application of the coating.
The maintenance of a ceramic treatment determines its lifespan (washing with neutral pH shampoo + ceramic-based booster ideally after each wash).

Labeling/Allergens

No. UFI: DW20-J050-900Q-JYJE

H315: Causes skin irritation.
H319: Causes serious eye irritation.
H412: Harmful to aquatic life with long lasting effects.

Dangerous, observe the safety precautions for use.