C1 Crystal Varnish

Dilution
None.

Use

1. First degrease the surface to be protected with the Panel Wipe.
2. Apply a few drops of C1 on the application pad.
3. Recap the bottle and set it down (do not hold it in your hand to avoid heating it, which could prematurely accelerate its hardening).
4. Regularly change the application pad (every 3 or 4 applications) so that it does not become sticky.
5. Once the C1 is applied (under normal ambient conditions), wipe it off after 30 seconds with moderate pressure (it is recommended to use 2 different microfibers to be sure not to forget to wipe an area).
6. Regularly fold your wiping microfiber to use the different sides.
7. Let the C1 bond with the varnish for at least 12 hours (ideally 24 hours) without contact with water.

Important
Always work in the shade, on a cool surface, and do not let the product dry.
Don't forget to wear your protective equipment: nitrile gloves and mask.
Once wiping is complete, immediately rinse your microfibers so that the C1 does not crystallize in the fiber. It is nevertheless recommended to subsequently assign these microfibers to another use than wiping the bodywork.

To be used within 12 months after purchase and within 3 months after opening.

Labeling/Allergens

UFI : Y1S2-109P-400T-7FT5

H225: Highly flammable liquid and vapors.
H412: Harmful to aquatic life, causes long-term adverse effects.

Dangerous, follow the precautions for use